200C Max. 6T Hydraulic Lamination Hot Press (12x12 cm area) - YLJ-HP60-LD

Feature

• Two heating platens are controlled by a digital temperature controller up to 200°C

• Platen Area: 120mm x 120mm
  
• Made of Aluminium alloy with the inserted heating element
• Warning: Please don't press a small area die directly against the soft Aluminium alloy surface. You may add a hard steel plate on top and bottom if press a small diameter die

Max. Working Temperature

• 200°C Max. (<30 minutes)
• 100°C continuous

• The single set point digital controller is installed in the control cabinet
• Temperature accuracy ±1°C

Max. Working Pressure

• 6 Metric Ton (Note: the machine base must be secured to an unmovable & solid table before operation)

Max. Opening 

• 30 mm between two heating plates

Gauge Pressure Value to Force Conversion

• Notes: 
• The actual force applied to the Hydraulic Cylinder (Ton) is equal to the force applied to your working piece
• For calculating the actual pressure (MPa) applied to your working piece, please follow the equations below:
• P = T/(πr^2) x g x 10
• P: Pressure (MPa) applied to your working piece
• T: Force (Ton) applied to the Hydraulic Cylinder 
• g: Standard gravity. g ≈ 9.8 m/s²
• π: ~3.14
• r: Radius (cm) of the working piece
• *1 Metric Ton = 1000 kg; 1 MPa ≈ 10 kg/cm²

Power Requirement

• 110VAC or 220VAC +/-10%, 50/60Hz, single-phase (please select the voltage in the selection bar)
• 1200 W max,15A circuit breaker is required 

Option

• Upgrade to Digital Pressure Gauge (100Kp to 60Mp) with $600 extra (Pic.1 & 2)
• We may install a digital load cell between the hot plate and hydraulic cylinder ( click Pic. 3 & 4 to order)

Compliance

• CE Certified 
• UL / CSA Certification is available upon request at extra cost